Seamless Gutters

What a gutter is actually there to do

A gutter has one job: catch the water coming off your roof and move it away from the house before it can do damage. In central Minnesota that water shows up as summer downpours, spring melt, and the slow refreeze at the eaves every winter. When gutters are undersized, pitched wrong, or leaking at the seams, that water ends up against your foundation, in the basement, or frozen into an ice dam that works its way under the shingles.

Most gutter problems people call us about are not really about the gutter face you can see. They are about seams that opened up, hangers that let go, and downspouts that were never big enough for the roof above them. Seamless gutters fix the first two by design, and sizing the system right fixes the third.

What “seamless” really means

Off-the-shelf gutters come in 10-foot sections. To go around a house you join a lot of those sections together, and every joint is a place that can leak, separate, or trap debris as the metal expands and contracts through Minnesota’s temperature swings.

We form your gutters on site instead. A run of coil aluminum feeds through a machine in the driveway and comes out as one continuous piece, cut to the exact length of your roofline. The only seams on the whole house are at the corners and where the downspouts drop. Fewer joints means fewer leaks and a cleaner line along the fascia.

How we hang them so they hold

The gutter is only as good as what holds it up. We use hidden hangers screwed straight into the fascia every couple of feet, not the old spike-and-ferrule setup that pulls loose after a few freeze-thaw cycles. Each run gets pitched so water actually travels to the downspouts instead of sitting in the low spots and breeding mosquitoes.

Before any new metal goes up, we look at what is behind the old gutter. If the fascia board or drip edge is soft, we deal with it then, while everything is open and easy to reach. Hanging new gutters over rotted wood is how you end up doing the job twice.

Sizing it for the roof above it

A steep or wide roof dumps a surprising amount of water at the eave in a hard rain. That is where 6-inch gutters and 3x4 downspouts earn their keep. They hold more, drain faster, and clog less than the standard 5-inch setup. On a simple ranch, 5-inch is usually plenty. We size the system to your roof, not to whatever is cheapest to stock, and we will explain the tradeoff at the estimate so you can decide.

Who tends to call us for this

New builds that need the whole perimeter done. Homeowners whose sectional gutters have started dripping at every seam. People tired of water pouring over the front edge onto the sidewalk, or finding it in the basement after every storm. If your gutters are pulling away from the house, rusting at the joints, or just too small for your roof, seamless is the fix.

What it costs

Every roofline is different, so we price after we measure yours. Length, height, the number of corners and downspouts, and whether the fascia needs any repair all move the number, and we break that down for you in writing. The estimate is free and there is no obligation to book. Send us a few details or call and we will come measure your roof and give you a straight price.